01787.pdf

(48 KB) Pobierz
3820 HD
(250-3572)
Power Utilities
Faxback Doc. # 1787
You can change several of the computer's power parameters by running the
Power program (Power382). The Power program temporarily overrides the Setup
program's power-management parameters.
To run the Power program, follow these steps:
1.
2.
3.
4.
Exit from the program you are currently in.
If you are not in Drive C, type: c:
Select the DOS directory by typing: cd \dos
At the prompt, type: Power382
press <ENTER>
The Power Management screen appears:
┌───────────────────────────────────────────────────┐
│
TANDY 3820 HD Power Management Options
│
│
│
│
POWER MANAGEMENT
OFF
│
│
│
│
SERIAL PORTS
ENABLED
│
│
│
│
HARD DISK TIMEOUT
Never Timeout
│
│
│
│
DISPLAY TIMEOUT
Never Timeout
│
│
│
│
STANDBY MODE TIMEOUT
Never Timeout
│
│
│
│
RESUME MODE
DISABLED
│
│
Timeout
Never Timeout
│
├───────────────────────────────────────────────────┤
│
ESC TO QUIT
F1 TO UPDATE
│
│
LEFT/RIGHT ARROW TO CHANGE UP/DOWN ARROW TO MOVE
│
└───────────────────────────────────────────────────┘
Note: You cannot enable Power Management parameters when using AC power.
If you make changes, the changes are ignored until you unplug the AC adapter
and switch to battery power.
The Power program lets you:
*
*
*
*
*
*
Enable and disable the power management
Enable and disable the serial ports
Set the hard disk timeout
Set the display timeout
Set the standby mode timeout
Set the resume mode timeout
Notes:
* The changes you make using the Power program are immediately active.
* The changes you make using the Power program are lost when you turn off
your computer. When you turn on your computer again, it returns to the
Setup parameters. However, if the Resume mode is active, the computer
retains the Power program settings (except hard disk timeout) until you
reboot or reset the computer.
(jej-05/10/94)

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin