IP.pdf

(1263 KB) Pobierz
BODY INTERIOR
SECTION
INSTRUMENT PANEL
IP
A
B
C
D
CONTENTS
PRECAUTION ..............................................
2
.
PRECAUTIONS ..................................................
2
.
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TEN-
SIONER" ..................................................................
2
.
Precaution Necessary for Steering Wheel Rota-
tion after Battery Disconnect ....................................
2
.
Service .....................................................................
3
.
E
SYMPTOM DIAGNOSIS ..............................
6
.
SQUEAK AND RATTLE TROUBLE DIAG-
NOSES ...............................................................
6
Work Flow ................................................................
6
.
Inspection Procedure ...............................................
8
.
Diagnostic Worksheet .............................................
10
.
F
G
H
REMOVAL AND INSTALLATION ..............
12
.
INSTRUMENT PANEL ASSEMBLY .................
12
Exploded View ........................................................
12
.
Removal and Installation ........................................
13
.
Exploded View ........................................................
22
.
Removal and Installation ........................................
23
.
Disassembly and Assembly ....................................
26
.
I
PREPARATION ...........................................
4
.
PREPARATION ..................................................
4
.
Commercial Service Tools ......................................
4
.
CENTER CONSOLE ASSEMBLY ....................
22
IP
CLIP LIST ...........................................................
5
.
Clip List ....................................................................
5
.
K
L
M
N
O
P
IP-1
PRECAUTIONS
< PRECAUTION >
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000006418044
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the “SRS AIR BAG” and
“SEAT BELT” of this Service Manual.
The vehicle may be equipped with a passenger air bag deactivation switch. Because no rear seat exists where
a rear-facing child restraint can be placed, the switch is designed to turn off the passenger air bag so that a
rear-facing child restraint can be used in the front passenger seat. The switch is located in the center of the
instrument panel, near the ashtray. When the switch is turned to the ON position, the passenger air bag is
enabled and could inflate for certain types of collision. When the switch is turned to the OFF position, the pas-
senger air bag is disabled and will not inflate. A passenger air bag OFF indicator on the instrument panel lights
up when the passenger air bag is switched OFF. The driver air bag always remains enabled and is not affected
by the passenger air bag deactivation switch.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the “SRS AIR BAG”.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
• The vehicle may be equipped with a passenger air bag deactivation switch which can be operated by
the customer. When the passenger air bag is switched OFF, the passenger air bag is disabled and
will not inflate. When the passenger air bag is switched ON, the passenger air bag is enabled and
could inflate for certain types of collision. After SRS maintenance or repair, make sure the passenger
air bag deactivation switch is in the same position (ON or OFF) as when the vehicle arrived for ser-
vice.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
• When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the
ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s)
with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly
causing serious injury.
• When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the
battery, and wait at least 3 minutes before performing any service.
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
INFOID:0000000006418048
NOTE:
• Before removing and installing any control units, first turn the ignition switch to the LOCK position, then dis-
connect both battery cables.
• After finishing work, confirm that all control unit connectors are connected properly, then re-connect both
battery cables.
• Always use CONSULT-III to perform self-diagnosis as a part of each function inspection after finishing work.
If a DTC is detected, perform trouble diagnosis according to self-diagnosis results.
For vehicle with steering lock unit, if the battery is disconnected or discharged, the steering wheel will lock and
cannot be turned.
If turning the steering wheel is required with the battery disconnected or discharged, follow the operation pro-
cedure below before starting the repair operation.
IP-2
PRECAUTIONS
< PRECAUTION >
OPERATION PROCEDURE
1. Connect both battery cables.
NOTE:
Supply power using jumper cables if battery is discharged.
2. Turn the ignition switch to ACC position.
(At this time, the steering lock will be released.)
3. Disconnect both battery cables. The steering lock will remain released with both battery cables discon-
nected and the steering wheel can be turned.
4. Perform the necessary repair operation.
5. When the repair work is completed, re-connect both battery cables. With the brake pedal released, turn
the ignition switch from ACC position to ON position, then to LOCK position. (The steering wheel will lock
when the ignition switch is turned to LOCK position.)
6. Perform self-diagnosis check of all control units using CONSULT-III.
A
B
C
D
Service
•
•
•
•
•
E
INFOID:0000000006275826
Disconnect battery negative terminal in advance.
Disconnect air bag system line in advance.
F
Never tamper with or force air bag lid open, as this may adversely affect air bag performance.
Be careful not to scratch pad and other parts.
When removing or disassembling any part, be careful not to damage or deform it. Protect parts, that may get
G
in the way with a shop cloth.
• When removing parts with a screwdriver or other tool, cover the tool surface with vinyl tape to protect parts.
• Keep removed parts protected with a shop cloth.
H
• If a clip is deformed or damaged, replace it.
• If an unreusable part is removed, replace it with a new one.
• Tighten bolts and nuts firmly to the specified torque.
• After reassembly is complete, check that each part functions correctly.
I
• Remove stains via the following procedure.
Water-soluble stains:
Dip a soft cloth in warm water, and then squeeze it tightly. After wiping off the stain, wipe with a soft dry cloth.
IP
Oil stain:
Dissolve a synthetic detergent in warm water (density of 2 to 3%), dip the cloth, then wipe off the stain with the
cloth. Next, dip the cloth in fresh water and squeeze it tightly. Then wipe off the detergent completely. Then
wipe the area with a soft dry cloth.
K
• Never use any organic solvent, such as thinner or benzine.
L
M
N
O
P
IP-3
PREPARATION
< PREPARATION >
PREPARATION
PREPARATION
Commercial Service Tools
Tool name
Description
INFOID:0000000006275827
Engine ear
Locates the noise
SIIA0995E
Remover tool
Removes clips, pawls and metal clips
JMKIA3050ZZ
IP-4
CLIP LIST
< PREPARATION >
CLIP LIST
Clip List
INFOID:0000000006275831
A
B
C
D
E
F
G
H
I
IP
K
L
M
N
O
P
JMJIA3734GB
IP-5

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin