FOKA01GBBT.PDF

(11 KB) Pobierz
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS
www.cobra.it
REV. 00
PETROL
DIESEL
X
MAKE
ALARM/SIREN
POSITION
POWER SUPPLY
FORD
MOD.
KA*
YEAR
01
→
* Models with original equipment keyless entry system.
Position the compact alarms and the sirens on the support of the servobrake, in the
engine compartment.
+ 30:
connect to the 3 mm RED wire located in the connections of the general input
in the fuse box.
2
- 31:
connect to the 2 mm BLACK wire located in the shunting of the general bulks
behind the sill cover, drivers side.
+ 15/54:
connect to the 1,5 mm JELLOW wire located in the black connector coming
out of the ignition key.
Connect to the 1,5 mm BLUE and BLUE/RED wire located in the wiring harness that
goes from the dashboard to the sill cover, drivers side.
Positive control signal
Front window, driver’s side:
cut the WHITE wire coming out of the respective push botton.
Front window, passenger’s side:
cut the WHITE/VIOLET wire coming out of the respective push botton.
Connections antithefts/vehicle
Art.3800
Vehicle
YELLOW/BLACK
YELLOW/RED
GREY/BLACK
WHITE/RED
VIOLET
YELLOW/BLACK
2
2
2
IGNITION WIRE
DIRECTION INDICATORS
ELECTRIC WINDOWS
ACTIVAT./DEACTIVATION
CONTROLS
Position
Central behind sill cover, drivers side
Central behind sill cover, drivers side
Negative control roof lamp lighting
from tx, central behind sill cover, drivers
side.
ORANGE
BLACK/ORANGE Negative control original direction
indicators in the central in the sill cover,
drivers side.
VIOLET/WHITE
Ground
Car body
ORANGE/WHITE
+30
Fuse box supply
Note:
In the central there are two YELLOW/BLACK wires, one of them is a fixed
positive, use the other YELLOW/BLACK wire.
+ 15 general:
cut the 2 mm BLACK wire located in the wiring harness coming out of
the connector of the ignition key.
2
IMMOBILISATION POINT
STARTER
+ 50:
cut the 2 mm YELLOW/BLACK wire located in the wiring harness coming out
of the connector of the ignition key. It is suggested to verify the function with a tester.
Install an additional switch on the front headlamp support plate, drivers side.
Connect to the 1 mm GREEN/BLACK wire located in the wiring harness under the
left sill cover, drivers side.
As the boot has not a courtesy lamp, it is necessary to install an additional switch.
2
2
BONNET SWITCH
DOORS SWITCH
BOOT SWITCH
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
foka01gbbt.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin